Articles Vegas Valley Beverage

Repair

8 Signs Your Commercial Coffee Brewer Needs Service

What to watch for

  • Coffee tastes weak, sour or bitter with the same coffee and grind. Brew temperature or volume is probably off, often from scale or a failing thermostat.
  • Brew cycles take longer than they used to. Scale is restricting the spray head or the inlet valve, or the water pressure to the brewer has dropped.
  • Batches come out short. A sticking inlet solenoid, a clogged strainer or a timer that needs calibration can cause this.
  • Water on the counter or under the brewer. Look for a worn tank gasket, a loose fitting or a cracked line, and shut the water off if it is more than a drip.
  • The brewer will not heat, or heats slowly. The heating element, thermostat, limit switch or a control board may be at fault.
  • The breaker trips. A shorted heating element or wiring problem is a safety issue. Leave the brewer off and call for service.
  • Spray head deposits or uneven wetting of the grounds. The spray head needs cleaning or descaling, and the coffee will extract unevenly until it is fixed.
  • Error codes, beeping or a display that freezes. Note the code before you power cycle so the technician can diagnose it faster.

Safe checks before you call

  • Confirm the water supply valve to the brewer is fully open and the filter is not past its capacity.
  • Check that the brew basket is seated correctly and the right spray head is installed.
  • Look at the breaker or the plug. Do not reset a breaker more than once if it trips again.
  • Clean the spray head with the manufacturer's cleaning method if it is visibly blocked.

Anything involving the heating element, wiring, thermostats or internal valves should be handled by a trained technician. Commercial brewers run on high-amperage circuits and hold water near boiling.

Keep brewers out of the shop

Filtration and a scheduled cleaning and calibration visit prevent most of the problems above. In Las Vegas, where the water is very hard, scale is the most common root cause. Vegas Valley Beverage services Bunn, Curtis, Newco and other commercial brewers 7 days a week. Request service.

Frequently asked questions

Why is my commercial coffee brewer brewing slowly?

Usually scale in the spray head or inlet valve, a clogged water strainer, a filter past its capacity or low water pressure to the brewer.

Why does my coffee brewer trip the breaker?

Most often a shorted heating element or a wiring fault. Leave it off and have it inspected by a technician.

Need a technician?

Vegas Valley Beverage services commercial coffee, espresso and tea equipment across the Las Vegas Valley, 7 days a week.

Related: Commercial coffee brewers · Bunn equipment